Change the batteries ........................5 Operation ......................... 5 Take a measurement ........................5 5.1.1 Change the measuring unit ......................5 5.1.2 Change the measuring mode ......................6 Calibration........................... 6 Contact ........................7 PCE Instruments UK ........................7 PCE Americas ..........................7...
Thank you for purchasing a coating thickness meter from PCE Instruments. The PCE-CT 28 coating thickness meter / gauge for cars is used to measure the thickness of paint and plastic coatings on ferrous or non-ferrous materials without damaging the coating surface. The coating thickness meter / gauge stands out by its high measurement range.
126 x 65 x 27 mm Weight 120 g (incl. batteries) Delivery contents 1 x coating thickness meter PCE-CT 28 1 x carrying case 2 x 1.5 V AAA batteries 1 x set of calibration standards 1 x instruction manual...
Manual System description General description Integrated sensor Display Zero / power button Battery compartment Change the batteries To change the batteries, please follow these steps: 1. Turn off the device. 2. Remove the cover of the battery compartment on the back of the device. 3.
Manual 5.1.2 Change the measuring mode There are two measuring modes available: single measurement and continuous measurement. To change the modes, press and hold the power button for approx. 8 seconds until the indication “SC” appears on the display. After that, release the power button. The measuring mode changes automatically. You can identify the current measuring mode by looking at the indication on the display.
In order to comply with the EU directive 2012/19/EU we take our devices back. We either re-use them or give them to a recycling company which disposes of the devices in line with law. If you have any questions, please contact PCE Instruments. Contact If you have any questions about our range of products or measuring instruments please contact PCE Instruments.