Table of Contents
Advertisement
10. Get on the bike and check the movement of the Drive Belt by rocking
back and forth on the pedals. The Pedals and Flywheel (G) should move
as one.
Adjust the Drive Belt tension again if necessary.
11. Tighten the Axle Nuts (D) when the Drive Belt tension is correct.
NOTICE: Make sure the Flywheel (G) is aligned with the Frame.
Be sure the Flywheel axle does not touch the Drive Belt
Inside (H).
12. Remove the right Pedal and Crank Arm. Reinstall the Drive Belt
Cover, Crank Arm and Pedal.
13. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner's
Manual.
18
Advertisement
Table of Contents
