Decomissioning And Disposal; Cabling Recommendations - Siemens RUGGEDCOM RSG909R Installation Manual

Chapter 1
Introduction
USB Type-B console port cable
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
Torx screwdriver
4 x M5 or #10-24 screws
Section 1.4

Decomissioning and Disposal

Proper decomissioning and disposal of this device is important to prevent malicious users from obtaining
proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of service, either permanently or
for maintenance by a third-party, make sure it has been fully decommissioned.
For more information, refer to the associated User Guide.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related accessories, contact a facility
certified to dispose of waste electrical and electronic equipment. Recycling and disposal must be done in
accordance with local regulations.
Section 1.5

Cabling Recommendations

All copper Ethernet ports on RUGGEDCOM products include transient suppression circuitry to protect against
damage from electrical transients and conform with IEC 61850-3 and IEEE 1613 Class I standards. This means that
during a transient electrical event, communications errors or interruptions may occur, but recovery is automatic.
Siemens also does not recommend using copper Ethernet ports to interface with devices in the field across
distances that could produce high levels of ground potential rise (i.e. greater than 2500 V), during line-to-ground
fault conditions.
4
Tools/Materials
For connecting to the RUGGEDCOM ROS console interface.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For attaching mounting brackets to the device.
For mounting the device to a panel.
RUGGEDCOM RSG909R
Installation Guide
Purpose
Decomissioning and Disposal