KaVo FOCUS 215720 Installation Manual page 50

4 Installation steps
44
4. Plug the black cord from the cable F3 between
the fuse F3 and mains switch connector (at the
back on the left side).
The narrow cable plugs fit the fuses and the
wide ones the mains switch connector slot
which is on the same side as the black cord in
the cable F52. Cable markings are found on the
cables.
NOTICE! Do not mix the cable F3 and the fuse
F3.
5. Twist the part a to the wall mounting bracket.
Tighten the part a and the counterpart b
together. Tighten the counterpart b by hand as
tight as possible and after that tighten it 1/4
round by tool.
6. Route the power supply cable through the cable
clamp and finally twist the part c to the part a
with strength of 6Nm.
FOCUS