KaVo FOCUS 215720 Installation Manual page 35

FOCUS
8. Attach the external exposure button to the
cable tie anchor on the control panel frame. Use
the included cable tie. Leave approx. 15
centimeters of free cable to connect the control
panel circuit board. Trim off the end of the
cable tie.
9. Cut out the relief in the control panel cover to
create an opening for the external exposure
button cable.
10. Move the DIP-switch "3" to position "OFF" on
the control panel circuit board to disable the
primary exposure button on the control panel
and enable only the external exposure button.
11. Carefully connect
connector X21 and the remote exposure button
cable to connector X23 pins "GND" and "2ND".
12.
Carefully install the control panel circuit board
to the control panel frame and attach the
control panel cover using the screw at the
bottom.
13. Attach the magnetic exposure button holder to
the optional electronics mounting plate on the
treatment unit and put the external exposure
button to the holder.
14. Route the Ethernet cable to the connection box
board of the FOCUS unit and connect it to
connector X63.
4 Installation steps
the Ethernet cable to
29