Table of Contents
Advertisement
Installation
5.2 Specifications for mounting linear motors
5.2
Specifications for mounting linear motors
Mounting system
The following specifications apply when mounting primary sections and secondary sections to
the machine:
• Use M5 screws with property class 10.9. (friction value μ
Table 5-1
Number of screws per motor type
4
1FN3050-1KD00
1FN3100-1KC50
1FN3150-1KC70
• Only use new screws that have not been used before.
• Ensure that the correct types of mounting screws are used to fasten the secondary sections:
– Cylinder head screws with standard head for 1FN3050 to 1FN3150 according to
• Ensure that the mounting surfaces are free of oil and grease and are clean and unpainted.
• Comply with the optimal surface roughness depth Rz of the screwing surface. Rz is between
10 and 40 μm.
• Minimize the number of joints. This keeps the settling effect for the material and the screws
low.
• Carefully maintain the specifications for the thread depths and screw-in depths in the primary
section.
• The tightening torque is 7.6 Nm.
Tighten the fixing screws using torque control. If you cannot tighten the fixing screws using
torque control, at least use a calibrated torque wrench with a short wrench insert.
You can increase the load capability of the screwed connection when using a tightening
procedure with controlled angle of rotation or yield limits.
• Tighten the screws gradually, with no jerky movements.
• To secure the screws, select a long clamping length l
Alternatively, use a medium strength threadlocker to prevent screws becoming loose, e.g.
Loctite 243.
• Minimize the amount that the screws settle. To do this, retighten all screws.
60
Number of screws
DIN EN ISO 4762 (hexagon socket-head screw) or DIN EN ISO 14579 (hexalobular screw)
8
1FN3050-2KC40
1FN3100-2KC50
1FN3150-2KC70
Operating Instructions, 06/2023, A5E52220465B AB
= 0.1).
tot
12
-
1FN3100-3KC50
1FN3150-3KC70
/d > 5.
k
Naturally-Cooled 1FN3 Linear Motors
Advertisement
Table of Contents
