Table of Contents
Advertisement
Decommissioning and disposal
10.2 Disposal
6. Remove the primary sections. Apply the installation technique in the inverse sequence.
When removing a linear motor with a divided secondary section track, you must first slide the
primary section on one end of the secondary section track, for example. Then remove the
first secondary section that is not covered. Pack the removed secondary section in the
original packaging before you remove the next secondary section. Proceed with the other
secondary sections in the same way.
Then you have to move the primary section to the end without secondary section and remove
the remaining secondary section track.
Only then can you disassemble the slide together with the linear guide and the primary
section.
7. Pack the motor components in the original packaging.
8. Correctly store the motor components.
❒
10.2
Disposal
Recycling and disposal
For environmentally-friendly recycling and disposal of your old device, please contact a
company certified for the disposal of waste electrical and electronic equipment, and dispose
of the old device as prescribed in the respective country of use.
Injury or material damage if not correctly disposed of
If you do not correctly dispose of direct drives or their components (especially components with
permanent magnets), then this can result in death, severe injury and/or material damage.
• Ensure that direct drives and their associated components are correctly disposed of.
116
WARNING
Naturally-Cooled 1FN3 Linear Motors
Operating Instructions, 06/2023, A5E52220465B AB
Advertisement
Table of Contents
