Set Up The Router As An Access Point - TP-Link EX1110 Manual

Chapter 4
• If you use Dynamic IP and
please go to Advanced >
• If you still cannot access the internet, refer to the
4 4

Set Up the Router as an Access Point

The router can work as an access point, transforming your existing wired network to a
wireless one.
1. Visit http://tplinkwifi.net
password you set for the router.
2. Go to Advanced >
will reboot and switch to Access Point mode.
3. After rebooting, connect the router to your existing wired router via an Ethernet cable.
4. Log in again to the web management page
and go to Quick Setup.
5. Configure your wireless settings and click Next.
6. Confirm the information and click Save. Now, you can enjoy Wi-Fi.
Tips:
• Functions, such as Parental Controls, QoS and NAT Forwarding, are not supported in the Access Point mode.
• Functions, such as Guest Network, are the same as those in the Router mode.
PPPoE and you are provided with any other parameters that are not required on the page,
Network > Internet to complete the configuration.
FAQ
or http://192.168.0.1, and log in with your TP-Link ID or the
Operation Mode, select
section for further instructions.
Access Point and click Save. The router
http://tplinkwifi.net
Set Up Internet Connection
or http://192.168.0.1,
18