Advertisement
AFTER INSTALLATION
Wobble
The fan blades have been adjusted in the factory to minimize any wobble
Note:
ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling, It would cause excess vibration. Movement of
A few centimeters is quite acceptable and does not suggest any problem to reduce the fan
Wobble: Please check that all screws which secured the mounting bracket and downrod are secure.
Balancing a wobbling ceiling fan:
1. Check that all blade and blade arm screws are secure.
2. Most fan wobbling problems are caused when blade levels are unequal. Check this level by electing a point on
the ceiling above the tip of one of the blades. Measure this distance. Rotate the fan until the next blade is
positioned for measurement. Repeat for each blade. The distance deviation should be equal within 1/8"(0.32cm).
3. If the blade wobble is still noticeable, Interchanging two adjacent (side by
side) blades can redistribute the weight and possibly result in smoother
operation.
Warning:
To reduce the risk of personal injury, Do not bend the blade
arm while installing, Balancing the blades, or cleaning the fan. Do not
insert foreign objects between rotating fan blades.
Noise
When it is quiet (especially at night) you may hear occasional small noises. This is normal.
Please allow a 24-hour "breaking-in" period, Most noises associated with a new fan disappear during the time.
Care and cleaning
1.Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to
avoid scratching the paint finish. Please make sure to turn off electricity power before you clean your fan
2.Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the
possibility of an electrical shock.
3.Motor has permanently lubricated ball bearing. No need to oil.
Note: Make sure the power is off at the electrical panel box before you attempt any cleaning or repairs.
Installation & Operating Instructions for the
Parrot Uncle Owner's Installation, Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
BBLAB011A
Touching
Ceiling
Advertisement
