Table of Contents
Advertisement
IV-3
4.3. Control-Tilt se nsor se tting
1
4
2
Control :
1- Position the control panel selector on "I".
2- Chock the rear wheels.
3- Place a spirit level (digital display) on the
chassis lengthways from (1) - (2) .
4- Using a jack of sufficient capacity, lift the front
of the chassis in (1) :
Stop as soon as the green light on the
sensor switches off (jerks linked to the
manoeuvre stopped). Read the angle of
the chassis: value (a).
5- Chock the front wheels.
6- Using a jack of sufficient capacity, lift the rear
of the chassis in (2) .
Stop as soon as Indicator light switches
off: value (b).
7- Place the spirit level across the chassis from
(3) - (4) .
8- Using a jack of sufficient capacity, lift the right
hand side of the chassis in (3) .
Stop as soon as Indicator light switches
off: value (c).
9- Using a jack of sufficient capacity, lift the left
hand side of the chassis in (4) .
Stop as soon as Indicator light switches
off: value (d).
NOTE
Ensure the tilt sensor rests correctly on the
support cap nuts.
Models
Toucan 861
Updated 04-06
ADJUSTMENTS
A
C
B
3
Spirit level
Niveau
électronique
Recordings
Authorized values
a+b
(c+d) ± 0,2°
a+b
3,6° to 4,0°
c+d
a
b
1,8° to 2,0°
c
d
PB1 : Replace tilt sensor.
PB2 : Replace tilt sensor.
PB3 : Adjust.
Adjustment :
- Position the machine that the chassis is
horizontal in the (1) - (2) and (3) - (4) directions
(blocks under the wheels).
Setting tolerance ±0.1°.
- Remove the protection of the calibration wire,
link it to the battery (-) until the sensor's green
light flashes.
- The sensor is adjusted.
- Reinstall the wire protection.
NOTE
If a symetry fault is corrected, the setting has
to be checked again in both direction before
the machine is returned to operation.
IV-3
Others refer to :
PB1
PB2
PB3
49
Advertisement
Table of Contents
