Right And Left Console Cover; Bottom Cover; Temperature Controller And Potentiometer (Gas Model); Hi Limit Thermostat (Gas Model) - Vulcan-Hart VGCTS16 Service Manual

ROUND COUNTERTOP TILTING BRAISING PANS (16 GALLON) Gas and Electric - REMOVAL AND
RIGHT AND LEFT CONSOLE
COVER
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
1. Remove screw at the rear of the cover.
2. Lift up on cover while working it back and forth to
free it at the front.
3. Reverse procedure to install.

BOTTOM COVER

Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
1. Tilt braising pan forward until it comes to rest on
the stop bar.
2. Remove screw(s) holding the round cover.
3. Reverse procedure to install.
TEMPERATURE CONTROLLER
AND POTENTIOMETER (Gas
Model)
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
Shut off the gas before servicing the
unit and follow lockout / tagout
procedures.
1. Remove right console cover as outlined under

RIGHT AND LEFT CONSOLE COVER.

F24643 (1217)
REPLACEMENT OF PARTS
2. Pull out the right side access panel to expose the
compartment controls.
3. Loosen the two set screws from the temperature
dial and pull off the dial.
4. Remove the bezel ring and potentiometer
mounting screws.
5. Remove the nut securing the potentiometer to
the mounting bracket.
6. Disconnect the lead wires from the temperature
controller board.
7. Remove the mounting screws.
8. Reverse procedure to install a new temperature
controller, then check for proper operation.

HI LIMIT THERMOSTAT (Gas Model)

1. Remove the bottom cover as outlined under
BOTTOM COVER.
2. Remove the screws securing the heat shield box
to the underside of the pan, and lift off.
Page 8 of 26
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
Shut off the gas before servicing the
unit and follow lockout / tagout
procedures.