Bearings; Limit Switch (Gas Model) - Vulcan-Hart VGCTS16 Service Manual

ROUND COUNTERTOP TILTING BRAISING PANS (16 GALLON) Gas and Electric - REMOVAL AND
Fig. 16
8. Gently strike the inner side of the support
member by hand or rubber mallet to dislodge the
pan assembly sleeve from the bearing. Before
the sleeve separates from the bearing, grasp the
pan for support.
Fig. 17
9. Grasp the pan firmly, and then pull it away from
the left side bearing.
NOTE: Check condition of both bearings while pan is
out, and replace if necessary.
10. Replace with a new pan, and reverse procedure
to install.

BEARINGS

Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
1. Remove the pan assembly as outlined under
PAN ASSEMBLY.
REPLACEMENT OF PARTS
2. Remove the bearing to be replaced from the
support member.
NOTE: Check condition of bearing on opposite side,
and replace if necessary.
3. Replace with a new bearing, and reverse
procedure to install.
1. Remove right console cover as outlined under
RIGHT AND LEFT CONSOLE COVER.
2. Pull out the right side access panel to expose the
compartment controls.
3. Disconnect the lead wires from the switch.
4. Tilt braising pan forward until it comes to rest on
the stop bar.
5. Remove the screws securing the switch to the
bracket.
6. Reverse procedure to install, and then check for
proper operation.
Page 13 of 26

LIMIT SWITCH (Gas Model)

Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
F24643 (1217)