ROUND COUNTERTOP TILTING BRAISING PANS (16 GALLON) Gas and Electric - REMOVAL AND
HEATING ELEMENTS
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
1.
Remove bottom cover as outlined under
BOTTOM COVER.
2.
Disconnect heater lead wires, and mark
accordingly for proper replacement.
Fig. 11
3.
From mounting stud, remove the two nuts that
secure the insulation pan to the bottom of the
braising pan.
4.
Push the heater lead wires back through the
opening in bearing to allow clearance for the
insulation pan to be lifted out.
5.
Remove the nuts securing the element clamp to
the braising pan bottom for the element being
replaced.
REPLACEMENT OF PARTS
6.
Replace with a new element, and reverse
procedure to install.
1.
Remove right and left console cover as outlined
under RIGHT AND LEFT CONSOLE COVER.
2.
Remove bottom cover as outlined under
BOTTOM COVER.
3.
Electric model only - for gas model, proceed to
Step 4.
A.
B.
4.
Gas model only.
Page 11 of 26
Fig. 12
PAN ASSEMBLY
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures. There may be
multiple circuits. Be sure all circuits
are disconnected.
Remove the heater lead wires and heating
elements as outlined under HEATING
ELEMENTS.
Proceed to Step 5.
F24643 (1217)