Table of Contents
Advertisement
(Dwg. TPD1920-1)
Assembly of the Reverse Valve
1. Coat a new Reverse Valve O-ring (31) with O-ring lubricant and install it in the groove on the Reverse Valve (32).
2. Install the Reverse Valve in the reverse valve bushing with the slotted end trailing, making sure that the index mark on the Reverse Valve is
aligned with the index mark on the Bushing. See Dwg. TPD1913.
(Dwg. TPD1913)
● The Reverse Valve must be installed and indexed with the bushing as directed in Step 2 and Dwg. TPD1913. Failure to do so will
cause improper operation of the Reverse Valve.
3. Insert the Reverse Lever (18) through the rear of the Backcap (16).
4. Slide the Reverse Lever Spring (20) over the shaft of the Reverse Lever and secure the Spring and Reverse Lever by installing the Reverse
Lever Snap Ring (19) in the groove in the shaft of the Reverse Lever. Rotate the Reverse Lever so that it is pointing to the symbol for
FORWARD (clockwise) operation. See Dwg. TPD1913.
TL-2922-MIM_ed1
ALIGN REVERSE VA
TIMING MARK WITH
MARK ON REVERSE
V V LVE BUSHING LO-
VA
L L
CATED IN HOUSING
A A
REVERSE LEVER IN
FORWARD POSITION
W W
NOTICE
V V LV
L L E
EN
5
Advertisement
Table of Contents
