Related Manuals for Ingersoll-Rand 2925Ti Series
Summary of Contents for Ingersoll-Rand 2925Ti Series
- Page 1 04584348 Edition 2 April 2006 Air Impact Wrench 2925Ti Series Maintenance Information Save These Instructions...
- Page 2 Grease Fitting (17). parts, lubricate the tool as follows: 2. Use Ingersoll Rand No. 50 Oil for lubricating the motor. 1. Work approximately 12 to 15 cc of Ingersoll Rand Inject approximately 1 to 2 cc of oil into the air inlet before No.
- Page 3 3. Hold the Hammer Frame firmly and, without disturbing 2. Remove the Backcap, Motor Clamp Washer (21) and the Hammers, gently lift the Anvil, simultaneously rotating Backcap Gasket from the Housing and set them aside on it clockwise about 1/8 of a turn, from Hammer Frame. a clean bench.
-
Page 4: Assembly Of The Impact Mechanism
Reverse Valve is aligned with the index mark on the Bushing. See Dwg. TPD1913. BOTTOM HAMMER WIDE BEVEL DOWN (Dwg. TPD652) 1. Coat the Hammers (35) with a light film of Ingersoll Rand No. 170 Grease. EN-4 04584348_ed2... - Page 5 4. Work approximately 12 to 15 cc of Ingersoll Rand No. 170 Grease into the impact mechanism. NOTICE 5. Smear a thin film of Ingersoll Rand No. 170 Grease on the inside surface of the Hammer Case Bushing (38) and When installing optional Hanger Kit, place Gasket on the place the Hammer Case (39) down over the Anvil and Hammer Case followed by the Hanger.
-
Page 6: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Dirty Inlet Bushing or Air Strainer Using a suitable cleaning solution, in a well ventilated area, clean Air Screen and/or Exhaust Silencer Strainer Screen, Inlet Bushing and Exhaust Silencer. Worn or broken Vanes Replace the complete set of Vanes. Low power Worn or broken Cylinder and/or Examine the Cylinder and replace it if it is worn or broken or if the bore is... - Page 7 Notes...
- Page 8 Ingersoll Rand © 2006 Company...