Shoprider ROCKY 8 Owner's Manual page 11

(2 & 3) Speed Controls
The speed control allows you to set a speed between 1 (minimum) and 10 (maximum).
Turn the dial knob counter-clockwise to "minimum" to decrease speed, and clockwise
towards "maximum" to increase your speed. The "High / Low" switch for extra speed.
Please use extra caution when using the scooter in "High" mode.
NOTE: When attempting to climb slopes, you will need to set the dial to "high" setting.
Remember the higher the number you set your speed dial to, the faster your scooter will
travel.
(4) Lights
A blue colored button operates the LED headlights.
(5) Horn
A yellow button operates the horn.
(6) Thumb/Finger Lever Controls
The left thumb/finger lever controls the reverse and the right thumb/finger lever controls the
forward motion. The amount of pressure applied to each lever will determine the speed the
scooter travels at. Release the lever and the scooter will slowly come to a stop and the
electromagnetic brake will be applied.
Electromagnetic Brake
The brake is automatically operated when the control levers are released. There is a slight
delay when the scooter decelerates; this allows the scooter to come to a smooth stop.
(7) On/Off Key Switch
Insert the key in the right side of the tiller. Turn the key on and the needle arm indicator will
indicate the battery charge. There is a delay before the thumb/finger lever control can be
operated, while the controller is checking the circuits.
(8) Indicator Switch
Two yellow triangle buttons operate the Right or Left indicator respectively. To depress the
button again will turn off the indicator.
(9) Hazard Warning Switch
A red button operates all indicators flashing.
11