Cleaning The Auto-Vent Valve - Graco EcoQuip 300 Operation, Repair, And Parts

Cleaning the the Auto Auto - - - Vent
Cleaning Cleaning the Auto
After the pop-up has been closed while filling the pot,
the auto-vent valve should release air (you should be
able to hear the air venting).
The pot pressure gauge will not show pressure until
the auto-vent valve has bled all of the air and sealed.
If the auto-vent valve does not release air, or if water
leaks from the stem during the fill process, the stem
valve may be clogged or faulty.
Perform the following procedure to clean a clogged
auto-vent valve.
1. Try to push and quickly release the valve with
your finger. If that does not cause the valve to
seal, open the dump valve to release all of the
pressure in the pot.
2. Turn the selector valve to RINSE.
334667B
Vent Valve Valve
Vent Valve
Get other manuals https://www.bkmanuals.com
3. Use the rinse hose to force water backwards into
the valve stem.
NOTE: If the previous steps fail to resolve
NOTE: NOTE:
the issue, replace the whole valve assembly
(EQ1860).
NOTICE NOTICE NOTICE
The valve stem itself is internally attached to the
float and it is not field-serviceable. Do not try to
remove the valve stem. Damage to the equipment
will occur.
Repair
31