Trampoline And Enclosure Assembly Instructions - Springfree SF60E Manual

TRAMPOLINE AND ENCLOSURE
ASSEMBLY INSTRUCTIONS
Read through the following steps before begin-
ning the assembly process.
Precautions
• Keep small children at least 25 feet away
while assembling or disassembling the tram-
poline; they could be injured by improperly
assembled rods releasing and ejecting from
the frame.
• Do not attempt to use the trampoline until it
is completely assembled.
• Two people are recommended for trampoline
assembly.
• Gloves are recommended during the assem-
bly process.
TRAMPOLINE
Straight Frame 2 Net
Sections
Curved Frame 4 Collapsible Rods
Sections
Legs 6 Horizontal Rods
Vertical Leg 6 C-Clips
Supports (attached to frame)
Rods 60
Mat 1
Bolt and Nuts 12
Wrench
2
Sandbags 4
Table 1: Parts Itinerary
Figure 1-A: The round sections being connected
Springfree Trampoline Model SF60E Trampoline and Enclosure Assembly, Installation, Care, Maintenance and Use Instructions Version 1.0
• Be aware that when loaded, the rods can
spring back and may cause injury.
• Treat any loaded rod with caution until you
are sure it is properly installed. In particular,
keep your face well clear of the rods during
assembly or disassembly. An improperly
installed rod could release and cause facial
injury or blindness.
• The sheath on the rod is intended to provide
protection from any fibreglass fibres or splin-
ters. Do not remove the sheath.
• Once a rod ball is in the socket in the mat, a
small clip automatically engages to lock it
in place. To release a rod ball from a socket,
push and hold the clip towards the mat cen-
tre before pushing the rod out of the socket.
Preparation
ENCLOSURE
1
Confirm all components are present (Table 1).
If you are missing any parts please call your
10
authorized Springfree service centre listed on
Page 28 of this manual.
2
10
Step 1: Assembling round
frame sections
Assemble both pairs of round frame sections,
with the leg sockets facing downwards
(Figure 1-A).
Step 1 details on following page
9