Springfree SF60E Manual page 11

vertical leg
support
Figure 3-A: The straight sections attached to the
round sections to make a complete oval shape
Figure 3-B: The correct (right) and incorrect (left)
orientation of the vertical leg supports.
joint
socket
Figure 4: Legs attached to the straight sections
Springfree Trampoline Model SF60E Trampoline and Enclosure Assembly, Installation, Care, Maintenance and Use Instructions Version 1.0
Step 3: Attaching the legs to the
round frame sections
Locate the joint between the two round frame
sections.
Attach a vertical leg support to the leg piece.
joint
Next, insert the leg with the support into the
sockets on the frame (Figure 3-A).
Note that the vertical leg support is off to
one side. Make sure the saddle of the vertical
leg support meets at the joint in the frame. If
it does not, remove the leg and turn it around
socket
(Figure 3-B).
Step 4: Attaching legs to
side sections
Locate a join between a straight frame section
and round frame section.
Attach a vertical leg support to the leg piece.
Next, insert the leg with the support into the
sockets on the frame (Figure 4).
Note that the vertical leg support is off to
one side. Make sure the saddle of the vertical
leg support meets at the joint in the frame. If
it does not, remove the leg and turn it around
(Figure 4).
Tip: This step is more
easily performed by
two people—one
person to lift the
frame and one person
to align the leg.
11