Springfree SF60E Manual page 17

socket
Figure 17: The enclosure rod being bent and inserted
into the socket
Figure 18: The completed trampoline with enclosure
Figure 19: The sandbags being filled
Springfree Trampoline Model SF60E Trampoline and Enclosure Assembly, Installation, Care, Maintenance and Use Instructions Version 1.0
Step 17: Bending the enclosure rod
into the socket
Bend the rod and insert the bottom end into
the socket on the frame (Figure 17). Ensure that
the rod is pushed right down into its socket and
locked in place by the C-Clip.
Step 18: Completing the enclosure
Continue around the tramp from right to left
installing all the enclosure rods.
The main trampoline and enclosure is now
complete; there remains one final step...
Step 19: Filling the sandbags
sfor stability
For increased stability, your trampoline comes
150 mm
with four sandbags that are to be placed over
each leg on the sides of the trampoline.
Fill bags to approximately 6 inches (150 mm)
below the top with wet or dry sand (Figure 19-
A), and then place one sandbag on each of the
four straight-oriented legs (Figure 19-B)
17