Table of Contents
Advertisement
9. Align holes in belt pulley and impeller shaft.
10. Install belt pulley roll pin using a punch and hammer.
11. Install twelve bolts and nuts securing tank shells together using a 2.5 mm Allen wrench and a 7 mm open end
wrench.
NOTE: Do not fully tighten bolts and nuts.
12. Torque the bolts to 9.5 in-lb (11 kg-cm). Only 1 to 2 bolt treads should protrude through the nut.
CAUTION: Do not over tighten bolts and nuts. Use tank replacement spacer jig that ships with a
replacement tank as a guide when tightening.
Item
1
2
Item
1
2
3
Item
1
2
Nut with 1 to 2 threads protruding
3
Page 31 of 47
Description
Belt pulley
Roll pin
Description
Bolt
Nut
Tank shell
Description
Bolt
Spacer jig, 6.6 mm width
Qty
1
1
Qty
12
12
2
Qty
12
12
1
Advertisement
Table of Contents
