Restore Factory Settings - HomeMatic HmIP-WRC6-A Mounting Instruction And Operating Manual

Restore factory settings

9 Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the wall-mount remote
control, please proceed as follows:
• To remove the remote control (B) from the frame,
take hold of the sides of the remote control and
pull it out (see figure 2).
• Remove one batterie.
• Insert the batterie ensuring that the polarity is
correct (see figure 7) while pressing and holding
down the system button (F) for 4s at the same
time, until the LED will quickly start flashing or-
ange (see figure 3).
• Release the system button.
• Press and hold down the system button again for
4s, until the status LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
48