Start-up
should be able to read the letters on the back side
(I) (see figure 4).
•
Remove the protective film from the adhesive strips.
•
Press the assembled wall-mount remote con-
trol with the back side to the wall in the position
where it should subsequently be attached.
5.2.2
Screw mounting
For mounting the wall-mount remote control using
screws, please proceed as follows:
•
Choose a site for installation.
Make sure that no electricity or similar lines run in
the wall at this location!
Position the mounting plate (G) on the desired
•
site on the wall. Make sure that the arrow on the
mounting plate is pointing upwards.
Use a pen to mark the positions of bore holes (J)
•
(diagonally opposite) in the mounting plate on
the wall (see figure 5).
•
Now drill the bore holes.
If you are working with a stone wall, drill the marked
two 5 mm holes and insert the plugs supplied. If you
are working with a wooden wall, you can pre-drill
1.5 mm holes to make screws easier to insert.
38