HomeMatic HmIP-WRC6-A Mounting Instruction And Operating Manual page 39

Use the supplied screws and plugs (L) to fasten
•
the mounting plate to the wall (see figure 6).
Attach the clip-on frame (A) to the mounting plate.
•
Place the remote control (B) back into the frame
•
(see figure 1). Make sure that the clips on the
mounting plate latch into the openings on the
electronic unit.
Information on installation with flush-mounting boxes:
• For installation with flush-mounting boxes, ple-
ase use the bore holes (K).
Note. Only to be installed by persons with the re-
levant electro-technical knowledge and experi-
ence!
Incorrect installation can put
• your own life at risk;
• and the lives of other users of the electrical sys-
tem.
Incorrect installation also means that you are running the
risk of serious damage to property, e.g. because of a fire.
You may be personally liable in the event of injuries or
damage to property.
Contact an electrical installer!
Start-up
39