HomeMatic HmIP-WRC6-A Mounting Instruction And Operating Manual page 43

do not need to open the device.
• Turn the remote control over to remove the bat-
teries.
• Insert two new 1.5 V LR03/micro/batteries into
the battery compartment, making sure that you
insert them the right way round (see figure 7).
• Put the remote control back into the frame. Make
sure that the clips on the mounting plate latch
into the openings on the electronic unit.
• Please pay attention to the flashing signals of the
device LED while inserting the batteries (see sec.
„8.4 Error codes and flashing sequences" on page
46).
Once the batteries have been inserted, the wall-mount
remote control will perform a self-test (approx. 2 sec-
onds). Afterwards, initialisation is carried out. The LED test
display will indicate that initialisation is complete by light-
ing up orange and green.
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries to
excessive heat. Do not short-circuit batteries. Do-
ing so will present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
Replacing batteries
43