Ziton ZP3-ECU Installation And Commissioning Manual page 17

Programming on a device basis
The ECU shown in diagram 5 of Figure 4 on page 7, is configured for its first
address to be 1005 and its second address to be 2025.
Diagram 1:
• Coincidence area one consists of device 1001
• Coincidence area two consists of device 2001
Diagram 3:
• Coincidence area one consists of devices 1001, 1002, and 1003
• Coincidence area two consists of devices 2001, 2002, and 2003
Both areas are programmed in a similar manner:
Diagram 1
Input Output
1001 1005 (ECU FIRST ADDRESS)
2001 2025 (ECU SECOND ADDRESS)
Diagram 3
Input Output
1001 1005 (ECU FIRST ADDRESS)
1002 1005 (ECU FIRST ADDRESS)
1003 1005 (ECU FIRST ADDRESS)
2001 2025 (ECU SECOND ADDRESS)
2002 2025 (ECU SECOND ADDRESS)
2003 2025 (ECU SECOND ADDRESS)
The same format and rules apply for any protected area.
ZP3-ECU Extinguishing Control Unit Installation and Commissioning Manual
Chapter 1: System wiring
Mode
SKNS (Single knock non silencing)
SKNS (Single knock non silencing)
Mode
SKNS (Single knock non silencing)
SKNS (Single knock non silencing)
SKNS (Single knock non silencing)
SKNS (Single knock non silencing)
SKNS (Single knock non silencing)
SKNS (Single knock non silencing)
9