Fitting The Attachment - Silvercrest SNIG 280 A1 Operating Instructions Manual

3) Open the cap 2. Fill 90 ml of water into the tank 1 using the measuring cup
9 and screw the cap 2 back on. The tank 1 must not be filled to the brim with
water since water could overflow when the cap 2 is inserted.
4) Pour any remaining water out of the appliance via the tank holder 3. To do this,
tilt the appliance so that the water flows out on the side of the tank holder 3
where the mains cable 4 is not located. Then dry the appliance with a dry
cloth.
5) Turn the tank 1 so that the cap 2 faces downwards. Place the tank 1 in the
tank holder 3.
6) As soon as the tank 1 is fully inserted, water runs into the appliance through
a water outlet.
Note: The cap 2 of the tank 1 is equipped with a water outlet so that the
inserted tank 1 can supply the appliance with water. If the water outlet does
not work properly, check that the cap 2 is assembled correctly (see section
Cleaning and maintenance, Fig. 5).

Fitting the attachment

1) Tilt the attachment 8 slightly (Fig. 1) and put it on the nozzle 6. The two hooks
on the back of the attachment 8 must engage in the recesses of the nozzle 6.
2) Turn the attachment 8 clockwise until the holder 7 is horizontal in the middle
of the attachment 8 (Fig. 2).
Fig. 1
3) To remove, turn back the attachment 8 and pull it off the nozzle 6.
SNIG 280 A1
Fig. 2
GB │ IE │
7 ■