Fitting The Strainer Attachment - Silvercrest SFW 350 C2 Operating Instructions Manual

5) Pull the pattern strips
6) First place the plastic disc and then the metal disc of the biscuit attachment
into the meat grinder casing
tachment
the openings in the meat grinder casing
7) After everything has been correctly assembled, screw the ring clamp
back on hand-tight.
8) Replace the pattern strips
Ensure that the grip on the pattern strips
If it does not, you will not be able to adjust the pattern, which is located
directly on the grip.
9) Assemble the meat grinder casing
meat grinder".
10) To dismantle it, you must first remove the pattern strips
screw the ring clamp

Fitting the strainer attachment

Unfold the fold-out page – it contains the step-by-step illustrations for assembling
the appliance. The figure displayed under point 8) will help you assemble the
appliance.
1) Remove the meat grinder casing
grinder".
2) Remove any attachments that might be fitted and clean the meat grinder
casing
NOTICE
► The transport screw
required for the strainer attachment! Remove these from the meat grinder
casing
3) Push the plastic screw
4) Push the strainer sieve
strainer sieve
of the strainer sieve
5) Once everything has been correctly attached, roll the ring clamp
strainer sieve
6) Fit the meat grinder casing
grinder".
7) Undo the locking clamp
8) Place the tomato outlet
strainer sieve
SFW 350 C2
away from the front of the biscuit attachment
. so that the fixings on the biscuit attachment
back in to the front of the biscuit attachment
open and take the biscuit attachment
.
and the cross blade
if necessary.
into the meat grinder casing
over the plastic screw
fit into the recesses in the meat grinder casing
should be facing downwards.
and screw it on hand-tight.
as described in "Assembling the meat
on the tomato outlet
under the strainer sieve by pushing the tip of the
through the small hole in the tomato outlet
(see fold-out side). Insert the biscuit at-
.
points away from the appliance.
as described under "Assembling the
as described in "Assembling the meat
with the spring
.
so that the tabs on the
.
GB │ IE │ NI │ CY
.
. are located in
.
before you can
back out.
are not
. The holes
over the
:
│ 9 ■