Assembling The Sausage Stuffer Attachment - Silvercrest SFW 350 D5 Operating Instructions Manual

5) Place your selected cutting disc 0 into the meat grinder casing 6 so that
the fixings on the cutting disc 0 are located in the openings in the meat
grinder casing 6.
6) After everything has been correctly assembled, screw the ring clamp q
back on hand-tight.
7) The ready-assembled meat grinder casing 6 is connected by a bayonet
connector to the motor unit 5:
Insert the meat grinder casing 6 into the motor unit 5 such that the
–
arrow on the meat grinder casing 6 lies against the symbol
motor unit 5. The locking button t presses itself in (Fig. B).
Lightly press the meat grinder casing 6 in and at the same time turn
–
the feeding shaft on the meat grinder casing 6 into the middle position
(Fig. B) so that the arrow on the feeding shaft points to the symbol
When the meat grinder casing 6 engages, the locking button t
springs out.
Finally, place the feeding tray 3 on top of the feeding funnel.
–
To dismantle it, press the locking button t and turn the feeding funnel to
–
the right (Fig. B)
Assembling the sausage stuffer attachment
Unfold the fold-out side - there you will find the step-by-step illustrations for
assembling the appliance.
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder".
2) Dismantle all parts which are fitted to/in the meat grinder casing 6 and
clean them.
3) Coat all metal parts with cooking oil.
4) Put the transport screw 7, the spring 8 and the cross blade 9 back into
the meat grinder casing 6.
5) Insert the sausage disc e so that the fixings on the sausage disc e are
located in the openings in the meat grinder casing 6.
6) Then place the sausage stuffer attachment w before the sausage disc e.
7) Screw the ring clamp q on hand-tight.
8) Assemble the meat grinder casing 6 as described under "Assembling the
meat grinder".
SFW 350 D5
. You can now pull the meat grinder casing 6 out.
on the
GB │ IE │ NI │ CY │
.
7 ■