Table of Contents
Advertisement
Combustor Replacement
Tools Required:
•
10 mm socket wrench with extension
•
3mm hex key
•
Work gloves
The combustor components are accessed by removal of the
top plate which is secured to the front plate by two M6 flange
nuts with M6 fender washers, fig. 19, and two M6x40 set
screws which are secured through the left and right sides, fig.
20.
Use the following instructions for combustor replacment:
1. Use the 10mm socket wrench with extension to remove
the two top plate M6 flange nuts with M6 fender washers
located behind the front plate inside the stove as in fig. 19.
2. Use the 3mm hex key to remove the two M6x40 set
screws on the left and right sides. See fig. 20.
3. Wearing gloves, grasp each side and lift the front of the top
plate slightly off of the front and side plates. See fig. 21.
4. Wearing gloves, use both hands to carefully remove the
Insulation Gasket (A) and large Insulation Panel(B) from
the firebox. Fig. 22.
5. Simply lift the catalytic combustor to remove it from the
compartment channel. Fig. 23.
6. Remove the Left and Right Side Refactory Members and
Expansion Gasket from the combustion chamber. Fig. 24.
7. Reassemble the catalytic combustion components in the
reverse order used to remove them.
Fig. 19. Remove both top plate nuts located inside the front ...........
door opening.
Set Screw
Fig. 20. Remove M6x40 set screws from left and right sides.
Fig. 21. Remove the top plate from stove.
A
B
Fig. 22. Insulation gasket (A) and Insulation panel (B).
139946_18 F 500 V3 Oslo
May 2022
Set Screw
Combustion Monitor
Set Screw
25
Advertisement
Table of Contents
