Catalytic Combustor Replacement - Jøtul F 500 V3 Series Installation And Operating Instructions Manual

Combustor Replacement
Tools Required:
• 10 mm socket wrench with extension
• 3mm hex key
• Work gloves
The combustor components are accessed by removal of
the top plate which is secured to the front plate by two
M6 flange nuts with M6 fender washers, fig. 19, and
two M6x40 set screws which are secured through the
left and right sides, fig. 20.
Use the following instructions for combustor
replacment:
1. Use the 10mm socket wrench with extension to
remove the two top plate M6 flange nuts with M6
fender washers located behind the front plate inside
the stove as in fig. 19.
2. Use the 3mm hex key to remove the two M6x40 set
screws on the left and right sides. See fig. 20.
2. Wearing gloves, grasp each side and lift the front of
the top plate slightly off of the front and side plates.
See fig. 21.
3. Wearing gloves, use both hands to carefully remove
the Insulation Gasket (A) and large Insulation
Panel(B) from the firebox. Fig. 22.
4. Simply lift the catalytic combustor to remove it from
the compartment channel. Fig. 23.
5. Remove the Left and Right Side Refactory Members
and Expansion Gasket from the combustion chamber.
Fig. 24.
6. Reassemble the catalytic combustion components in
the reverse order used to remove them.
Fig. 19. Remove both top plate nuts located inside the front .
door opening.
Set Screw
Fig. 20. Remove M6x40 set screws from left and right sides.
Fig. 21. Remove the top plate from stove.
A
B
Fig. 22. Insulation gasket (A) and Insulation panel (B).
F 500 V3 Oslo 4 / 20
Set Screw
Combustion
Monitor Set Screw
25