Installing The Cover Of The Headlight Mask Rack; Checking The Headlight Setting - KTM 890 DUKE GP 2022 Owner's Manual

16 ELECTRICAL SYSTEM
16.11
16.12
100

Installing the cover of the headlight mask rack

V01219-10
V01218-10

Checking the headlight setting

400726-10
Main work
–
Position cover by guiding the plug-in connector of the head-
light through the opening.
–
Hold turn signal in the area
direction of travel, while pressing the cover tight at the same
time.
The cover engages with an audible click.
–
Repeat the operation on the opposite side.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
–
Mount and tighten screws
Guideline
Screw, headlight
Finishing work
–
Mount the headlight mask with the headlight. (
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
Guideline
B
Distance
–
Position the vehicle perpendicular to the wall at a distance
from the wall and switch on the low beam.
Guideline
A
Distance
–
The rider now mounts the motorcycle with luggage and passen-
ger if applicable.
–
Check the headlight setting.
A
and carefully press against the
1
.
M5 5 Nm (3.7 lbf ft)
2
.
EJOTPT ® 3 Nm (2.2 lbf ft)
K50x14
p. 98)
p. 100)
B
under the first marking.
5 cm (2 in)
5 m (16 ft)
A