WMBH – Wall Mount Battery Holder – Proflame 1 and 2 IPI Models - Option
The WMBH provides the option for a more convenient and accessible location for the backup batteries.
NOTE: The WMBH is NOT a remote control receiver. It functions as a Battery Holder and mode selector switch ONLY.
⚠
CAUTION
DO NOT PLUG THE ORIGINAL BATTERY HOLDER SUPPLIED WITH THE
-
APPLIANCE INTO THE WMBH WIRING HARNESS. - NOT FOR USE WITH POWER VENTS -
Parts List:
[1] Battery Holder
[1] DCHS Mount Bracket
[1] Wall Mount Cover Plate
[1] 16 ft. Wiring Harness
White
Square
Connector
Proflame 1:
-Plug Battery
Connector into Battery
Holder connection on
wiring harness.
-The Square Plug
Connector on the 16ft
wiring harness is not
used.
Proflame 2:
-Plug the Square Plug
Connector into the
User Interface Socket
in the P2 Module.
-Plug the Battery
Connector into Battery
Holder connection on
the Proflame 2 wiring
harness.
Installation:
• The Battery Holder can be mounted on a vertical wall stud using the DCHS
as a mounting bracket.
• Ensure that the face is protruding 1/2" so that the face plate will be flush on
the face of the wall.
• Drywall cutout size is 2" wide by 4-1/8" tall.
• Must be installed within 16ft of valve assembly (12ft recommended).
Operating Instructions:
• Proflame 1: Set the switch on the Battery Holder to either the ON or REMOTE
position. The WMBH functions as a battery backup should a power outage occur.
• Proflame 2: Set the switch on the Battery Holder to the REMOTE position.
NOTE: If the switch on the Battery Holder is set to ON, the remote control will be
disabled. The WMBH functions as a battery backup should a power outage
occur. Refer to the manual that accompanies the Battery Holder for further
instructions.
DCHS Mount
DISCARD
Bracket
ORIGINAL
BATTERY
White
Square
Connector
HOLDER
68