Titan TTB878GRD Manual page 6

EN
Angle grinder safety warnings
Safety warnings common for grinding and abrasive cutting-off operations:
This power tool is intended to function as a grinder or cut-off tool. Read
all safety warnings, instructions, illustrations and specifications
provided with this power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Operations such as sanding, wire brushing, polishing or hole cutting
are not to be performed with this power tool. Operations for which the
power tool was not designed may create a hazard and cause personal injury.
Do not convert this power tool to operate in a way which is not
specifically designed and specified by the tool manufacturer. Such a
conversion may result in a loss of control and cause serious personal injury.
Do not use accessories which are not specifically designed and
specified by the tool manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe operation.
The rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool. Accessories running faster
than their rated speed can break and fly apart.
The outside diameter and the thickness of your accessory must be
within the capacity rating of your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
The dimensions of the accessory mounting must fit the dimensions of
the mounting hardware of the power tool. Accessories that do not match
the mounting hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
Do not use a damaged accessory. Before each use inspect the
accessory such as abrasive wheels for chips and cracks, backing pad
for cracks, tear or excess wear, wire brush for loose or cracked wires. If
power tool or accessory is dropped, inspect for damage or install an
undamaged accessory. After inspecting and installing an accessory,
position yourself and bystanders away from the plane of the rotating
accessory and run the power tool at maximum no-load speed for one
minute. Damaged accessories will normally break apart during this test time.
6
TTB878GRD by TITAN