Table of Contents
Advertisement
EN
the possible kickback may propel the spinning wheel and the power tool
directly at you.
c) When the wheel is binding or when interrupting a cut for any reason,
switch off the power tool and hold it motionless until the wheel comes
to a complete stop. Never attempt to remove the cut-off wheel from the
cut while the wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the cause of wheel binding.
d) Do not restart the cutting operation in the workpiece. Let the wheel
reach full speed and carefully re-enter the cut. The wheel may bind, walk
up or kickback if the power tool is restarted in the workpiece.
e) Support panels or any oversized workpiece to minimize the risk of
wheel pinching and kickback. Large workpieces tend to sag under their
own weight. Supports must be placed under the workpiece near the line of cut
and near the edge of the workpiece on both sides of the wheel.
f)
Use extra caution when making a "pocket cut" into existing walls or
other blind areas. The protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kickback.
g) Do not attempt to do curved cutting. Overstressing the wheel increases the
loading and susceptibility to twisting or binding of the wheel in the cut and the
possibility of kickback or wheel breakage, which can lead to serious injury.
Safety warnings for bonded abrasive wheels
General
Abrasives are breakable and shall therefore be handled with utmost care! The
use of damaged or improperly mounted or used abrasives is dangerous and can
cause serious injuries.
Delivery, handling and storage
Abrasives shall be handled and transported with care.
Abrasives shall be stored in such a manner that they are not subjected to
mechanical damages and harmful environmental influences.
Selection of abrasives
Information on the label or the abrasive as well as restrictions of use, safety
indications or any other instruction shall be followed. In case of doubt concerning
10
TTB878GRD by TITAN
Advertisement
Table of Contents
