Beko WRE 6512 ZSW Manual page 51

A
WARNING:
the machine against any freezing possibility in the region of installation.
WARNING:
In order to clean the dirty filter and discharge the water:
1 Unplug the machine to cut off the supply power.
A
WARNING:
the filter after the water in the machine cools down.
2 Open the filter cap.
3 Some of our products have emergency draining hose and some does not have. Follow the steps below
to discharge the water.
Discharging the water when the product has an emergency draining hose:
a Pull the emergency draining hose out from its seat
b Place a large container at the end of the hose. Drain the water into the container by pulling out the plug
at the end of the hose. When the container is full, block the inlet of the hose by replacing the plug. After
the container is emptied, repeat the above procedure to drain the water in the machine completely.
c When draining of water is finished, close the end by the plug again and fix the hose in its place.
d Turn the pump filter to take it out.
51 / EN
If the product is not in use, turn the tap off, detach the supply hose and drain the water inside
After each use close the supply hose tap of the product.
Temperature of the water inside the machine may rise up to 90 ºC. To avoid burning risk, clean
Washing Machine / User's Manual