Beko WRE 6512 ZSW Manual page 37

2.2 Removing packaging reinforcement
2.3 Removing the transportation locks
A
WARNING:
WARNING:
the product will be damaged.
1. Loosen all the bolts with a suitable spanner until they rotate freely (C) .
2. Remove transportation safety bolts by turning them gently.
3. Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P)
C
Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved
again in the future.
Never move the product without the transportation safety bolts properly fixed in place!
2.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 10 MPa). It is necessary
to have 10 – 80 liters of water flowing from the fully open tap in one minute to have your machine run
smoothly. Attach a pressure reducing valve if water pressure is higher.
If you are going to use the double water-inlet product as a single
supplied stopper to the hot water valve before operating the product. (Applies for the products supplied
with a blind stopper group.)
A
WARNING:
the laundry will get damaged or the product will switch to protection mode and will not operate.
WARNING:
laundry.
2.5 Connecting to the drain
• The end of the drain hose must be directly connected to the wastewater drain or to the washbasin.
A
WARNING:
Moreover, there is risk of scalding due to high washing temperatures! To prevent such situations and to
ensure smooth water intake and discharge of the machine, fix the end of the discharge hose tightly so that
it cannot come out.
37 / EN
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by
pulling the ribbon.
Do not remove the transportation locks before taking out the packaging reinforcement.
Remove the transportation safety bolts before operating the washing machine! Otherwise,
Models with a single water inlet should not be connected to the hot water tap. In such a case
Do not use old or used water inlet hoses on the new product. It may cause stains on your
1. Tighten all hose nuts by hand. Never use a tool when
tightening the nuts.
2. Open the taps completely after making the hose connection
to check for water leaks at the connection points. If any
leaks occur, turn off the tap and remove the nut. Retighten
the nut carefully after checking the seal. To prevent water
leakages and damages caused by them, keep the taps
closed when the machine is not in use.
Your house will be flooded if the hose comes out of its housing during water discharge.
(cold)
water-inlet unit, you must install the
Washing Machine / User's Manual