Removing And Fitting The Appliance Door; Cleaning The Door Panels - NEFF B15E62 0 Series Instruction Manual

Cleaning up and switching off
Do not leave the remaining water in the cooking compartment
for a long time (e.g. overnight).
Open the appliance door and remove the remaining water
1.
with an absorbent sponge cloth (Fig. B).
Clean the cooking compartment with a sponge cloth, a soft
2.
brush or a plastic saucepan scrubber.
Note. You can remove any remaining, persistent residue with
a glass scraper for glass ceramic.
Remove limescale with a cloth soaked in vinegar, then wipe
3.
with clean water and rub dry with a soft cloth. Remember to
dry under the door seal.
Turn the operating mode selector back to the
4.
After cleaning, leave the appliance door ajar in the stop
5.
position (approx. 30°) for approx. 1 hour to allow the enamel
surfaces in the cooking compartment to dry thoroughly.
Rapid drying
After cleaning, leave the appliance door ajar in the stop
1.
position (approx. 30°).
Set 3 CircoTherm® at 50 °C.
2.
After 5 minutes, switch off the appliance and close the
3.
appliance door.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
ã=
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
ã=
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A)
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
$
Û position.
%
Fitting the appliance door
Insert the hinges in the left and right-hand holders (figure C).
1.
The notch on both hinges must engage.
Open the appliance door fully.
2.
Close the locking levers on the left and right-hand side fully
3.
(figure D).
&
The appliance door is secured and can no longer be
removed.
Close the appliance door.
4.

Cleaning the door panels

To facilitate cleaning, you can remove the door panels from the
appliance door.
ã=
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Unhook the appliance door and lay it on a soft, clean surface
1.
with the front side facing downwards (see section:Removing
and installing the appliance door).
Grip the door panel next to the hinges and pull it out of the
2.
plug-in holders (not visible).
Lift the door panel slightly and remove it in the direction of the
3.
hinges.
Removing the intermediate panel
Before removing, make a note of the position in which the
intermediate panel is fitted, so that you do not refit it the wrong
way round later.
Press the left and right-hand holders outwards.
1.
The intermediate panel disengages upwards.
Lift the intermediate panel slightly (e.g. with a spatula) and
2.
remove it.
'
21