Grandstream Networks GWN76 Series User Manual page 61

Enable Schedule
Disable Port
NET/PoE Link Type
PVID
Allowed VLAN(s)
Disable 2.4GHz/5GHz
Channel Width
Channel
Radio Power
Enable Minimum RSSI
Minimum Access Rate Limit
Wi-Fi5 Compatible Mode
Note:
The administrator can filter access points by Model or search by name/MAC of the device. Click on Save Button to save the
changes and apply them to the AP.
Reset Access Points
To reset an access point, select and click on
confirm the operation.
5G in Priority: 5G Band will be prioritized over 2G Band
Balance: GWN will balance between the clients connected to 2G and those connected to 5G.
Use Radio Settings: GWN will use the value configured under Radio page.
Configure a schedule for when the Wi-Fi will be ON or Off, by default is disable or the user can
enable it and select a shedule form the drop-down list or use radio settings.
Select "NET" from the drop-down list to disable the Ethernet NET port.
If GWN76xx access point is connected to a router or a switch, the NET/PoE port can by configured as
a Trunk or Access.
Configures the VLAN ID of the port
Configures the VLAN ID(s) allowed to pass through the port. Multiple VLAN IDs can be entered such
as 1,2,3,7. Up to 16 VLAN IDs can be configured. If no value is configured, the port allows all
VLANs
2.4G/5G (802.11b/g/n/ax)
This feature allows the user to disable/enable its 2.4GHz/5GHz band on the AP.
Choose the Channel Width, note that wide channel will give better speed/throughput, and narrow
channel will have less interference. 20Mhz is suggested in very high-density environment. Default is
"Use Radio Settings", the AP then will use the value configured under Radio page.
Select Use Radio Settings, or a specified channel, default is Auto. Note that the proposed channels
depend on Country Settings under System Settings → Maintenance. Default is "Use Radio Settings",
the AP then will use the value configured under Radio page.
Set the Radio Power depending on desired cell size to be broadcasted, five options are available:
"Low", "Medium", "High", "custom" and "Use Radio Settings".
The default is "Use Radio Settings", the AP then will use the value configured under the Radio page
Configures whether to enable/disable Minimum RSSI function. This option can be either Disabled or
Enabled and set manually or set to Use Radio Settings.
Specify whether to limit the minimum access rate for clients. This function may guarantee the
connection quality between clients and AP. This option can be either Disabled or Enabled and set
manually or set to Use Radio Settings.
Some old devices do not support Wi-Fi6 well and may not be able to scan the signal or connect poorly.
After turning on this switch, it will switch to Wi-Fi5 mode to solve the compatibility problem. At the
same time, it will turn off Wi-Fi6 related functions.
Access Point Configuration Settings
button, a confirmation message will be displayed, click on to