Adjusting Screws - KTM SUPERMOTO FACTORY REPLICA 660SMS 2004 Owner's Manual

1
22

Adjusting screws

The two adjusting screws 1 on the left and right side of the bike are used
to adjust the tail and may not be turned.
1
B
OTH ADJUSTING SCREWS MUST BE CHECKED FOR DISTORTION AND CRACKS AFTER A
.
FALL
Adjusting of basic position at the hand brake lever
The basic position of the hand brake lever may be readjusted by using
adjustment screw
the resistance you feel on the hand brake lever when the brake pads are
2
pressed against the brake disc) can be adjusted for any hand size.
Checking of brake fluid level - front brake
The brake fluid reservoir is mounted on the handlebars. The brake fluid
level should not drop below the MIN mark in a horizontal position. If
necessary, add DOT 5.1 brake fluid (e.g. Motorex Brake Fluid 5.1).
– I
F THE BRAKE FLUID LEVEL DROPS BELOW THE MINIMUM EITHER THE BRAKE SYSTEM
HAS A LEAK OR THE BRAKE PADS ARE COMPLETELY WORN
AUTHORIZED
– T
HE BRAKE FLUID RESERVOIR MUST BE MOUNTED IN A HORIZONTAL POSITION
OTHERWISE AIR CAN GET INTO THE BRAKE SYSTEM
Checking the rear brake fluid level
The reservoir for the rear disk brake is located in the air filter box under the
seat.The brake fluid level must not drop below the "MlN" marking when
the vehicle is in an upright position.
I
F THE BRAKE FLUID LEVEL DROPS BELOW THE MINIMUM EITHER THE BRAKE SYSTEM HAS A
LEAK OR THE BRAKE PADS ARE COMPLETELY WORN
KTM
RIZED
WARNING
2
. In this way, the position of the point of pressure (i.e.,
WARNING
KTM .
DEALER IMMEDIATELY
WARNING
.
DEALER IMMEDIATELY
. I ,
N THIS CASE CONSULT AN
.
. I ,
N THIS CASE CONSULT AN AUTHO
,
-