Security; Boot - DFI ICX610-C621A-000G User Manual

X Security
InsydeH2O Setup Utility

Security

Current TPM Device <TPM 2.0 (FTPM)>
TPM State All Hierarchies Enabled, UnOwned
TPM Availability <Available>
TPM Operation <No Operation>

Boot

Clear TPM [ ]
Supervisor Password Not installed
Set Supervisor Password
T P M Av a i l a b i l i t y
Available
Hidden
F1 Help ↑ /↓ Select Item
Esc Exit ←/→ Select Item
TPM Availability
Show or hide the TPM availability and its configurations.
TPM Operation
Select one of the supported operation to change TPM2 state — No Operation, Enable, or Dis-
able.
Clear TPM
Remove all TPM context associated with a specific Owner.
Set Supervisor Password
Set the supervisor's password. The length of the password must be greater than one character.
Note:
The devices shown here are based on a carrier board that may not resemble your
actual carrier board. The actual I/O devices depend entirely on those present on
your actual carrier board.
User's Manual | ICX610-C621A
W h e n H i d d e n , d o n ' t e x -
poses TPM to 0
Exit
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit
X
X Boot
Rev. 5.0
Main Advanced Security
Numlock
Boot Type
Network Stack
PXE Boot capability
USB Boot
►EFI
►Legacy
F1 Help
Esc Exit
Numlock
Select the power-on state for numlock.
Boot Type
Select the boot type — UEFI Boot Type, Legacy Boot Type or Dual Boot Type. If you select "UEFI
Boot Type" or "Dual Boot Type", the "Network Stack", "PXE Boot capability", "USB Boot" and
"Quiet Boot" will show up. If you select "Legacy Boot Type", "PXE Boot to LAN", "USB Boot" and
"Quiet Boot" will show up.
Note:
Please press F10 to save the settings and re-start the system board after changing
"Boot Type".
Network Stack
This field is used to enable or disable network stacks, i.e. IPv4 or IPv6 network protocols.
InsydeH2O Setup Utility
Boot Exit
<On>
<Dual Boot Type>
<Disabled>
<Disabled>
<Enabled>
↑ /↓ Select Item F5/F6 Change Values
←/→ Select Item Enter Select SubMenu
X
Chapter 3
BIOS SETTINGS
Rev. 5.0
Select Power-on state for
Numlock
F9 Setup Defaults
F10 Save and Exit
43