Security - DFI AL173 User Manual

Smart Fan Function
This section configures the Smart Fan Function.
InsydeH2O Setup Utility
Advanced
Smart Fan Function
SYS Smart Fan1 Control <Enable>
Boundary 1 [30]
Boundary 2 [40]
Boundary 3 [50]
Boundary 4 [60]
Fan Speed Count 1 [35]
Fan Speed Count 2 [60]
Fan Speed Count 3 [80]
Fan Speed Count 4 [100]
SYS Smart Fan2 Control <Enable>
Boundary 1 [30]
Boundary 2 [40]
Boundary 3 [50]
Boundary 4 [60]
Fan Speed Count 1 [35]
Fan Speed Count 2 [60]
Fan Speed Count 3 [80]
Fan Speed Count 4 [100]
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→  Select Item Enter
SYS Smart Fan1/Fan2 Control
Enable or disable the system smart fan. If disabled, Fix Fan Speed Count field ranges
from 1 to 100% (full speed) will appear.
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the operation of the fan with different
fan speeds accordingly. For example, when the system or the CPU temperature reaches
boundary 1 temperature, the system or CPU fan should be turned on and operate at
the designated speed. The range is from 0-127
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed. The range is from 1 to 100% (full speed). The fans will operate
according to the specified boundary temperatures above.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable/Disable Smart Fan
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

C.
o

Security

This section configures the security settings for entering the BIOS setup utility.
Main Advanced Security
Current TPM Device <TPM 2.0 (FTPM)>
TPM State All Hierarchies Enabled, Owned
TPM Availability <Available>
TPM Operation <No Operation>
Clear TPM [ ]
Supervisor Password Not installed
Set Supervisor Password
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
TPM Availability
Show or hide the TPM availability and its configurations.
TPM Operation
Select one of the supported operation to change TPM2 state.
Clear TPM
Remove all TPM context associated with a specific Owner.
Set Supervisor Password
Set the supervisor's password and the length of the password must be greater than
one character.
39
InsydeH2O Setup Utility Rev. 5.0
Boot Exit
Select one of the supported
operation to change TPM2
state.
TPM Operation
No Operation
Enable
Disable
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com