Direct Control Menu - Eneo TVB-2080Z03IR Quick Installation Manual

2. ▼ : Zoom Out
3. ◄ : Focus Near
4. ► : Focus Far
Press '●' (OSD menu Joy stick key) down for about 2 seconds to access the setup menu
mode.
Lens Initializing is strongly recommended at the first stage of setup menu control. ZOOM/
FOCUS > LENS INIT > Press the joystick '☟' straight down for about 2 seconds.
MENU
1. ZOOM/FOCUS
2. EXPOSURE
3. SCENE ENHANCE
4. 3D-NR
5. DAY/NIGHT
6. PICT ADJUST
7. SPECIAL
8. SYSTEM
9. EXIT

Direct control menu

MAIN
ZOOM/FOCUS
EXPOSURE
SCENE ENHANCE
3D-NR
12
V3.xx
↵
↵
NORMAL
MID
EXT
↵
↵
↵
↵
↵
SAVE&EXIT
DEFAULT DESCRIPTION
- Sets FOCUS MODE, D-ZOOM, HOME POSITION, LENS REFRESH and LENS INIT
- Sets EXPOSURE MODE, BRIGHTNESS, SENS-UP, AGC and MOTION DEBLUR.
SCENE ENHANCE provides the several ways to enhance the video in the various
environments with the settings in NORMAL, WDR, D-WDR, BLC and HLC.
NORMAL – Optimized for the normal indoor and outdoor in the good lighting
condition.
WDR – Improves the visibility for the high bright area and the darkarea by the
double captures of image with LONG and SHORT exposures. With WDR ON, the
frame rate becomes half by the double captures. WDR level can be selected from
LOW, MID and HIGH. Care should be taken to select this mode because video may
lose its quality in some environments by the over compensation.
NORMAL CVBS video signal: Connecting 2nd video to CVBS port disables WDR function tem-
porary. It should be considered when installer adjusts the video with installation
monitor via CVBS video signal.
D-WDR – Improves the visibility by compensating the video gain for the dark
area. Noise can increase in the dark area accordingly.
BLC – Improves the visibility for the dark object by the bright back light. Outside
area of BLC window can over saturate. BLC has a target window for compensation
and its size and position can be set by H-POS, V-POS, H-SIZE and V-SIZE.
HLC – Cuts out the highlight area with black mask and excludes it from compen-
sation. Lower HLC LEVEL cut out video from the lower level.
MID Sets 3DNR level. OFF, LOW, MID, HIGH