Spray Arm Monitoring/Conductivity/Wash Pressure - Miele PG 8582 CD Operating Instructions Manual

Problem solving guide

Spray arm monitoring/conductivity/wash pressure

Problem
Spray arm monitoring - upper
spray arm: Spray arm blocked
or excessive foaming
or
Spray arm monitoring - lower
spray arm: Spray arm blocked
or excessive foaming
or
Spray arm monitoring - mobile
unit spray arm 1 - : spray arm
blocked or excessive foaming
Conductivity level too high:
Actual value: µS/cm Max
value: µS/cm
Conductivity level exceeds
max. value
Conductivity module requires
calibration
Conductivity module commu-
nication error
138
Cause and remedy
The set spin speed has not been reached.
– Load items are obstructing the machine or basket spray
arms.
Arrange the load items so that the spray arms can turn

easily and start the programme again.
– The relevant spray arm is blocked.
Clean the spray arm.

Check whether the filters in the wash cabinet are clean

and correctly inserted.
Start the programme again.

– Wash pressure is too low due to a heavy build-up of
foam.
Follow the instructions regarding foam build-up in

"Chemical processes and technology".
Rinsing
Start the programme in order to clean the wash

cabinet.
Then reprocess the load items again.

Carry-over of conductive substances during reprocessing.
Check the process.

Empty or faulty water softener or demineralisation system.
Check external water softener or demineralisation

systems.
Reactivate the systems if necessary.

Work on the on-site water supply.
Contact a suitably qualified plumber.

Plumbing connections transposed.
Observe the markings on the plumbing connections (see

"Connection to the water supply").
If the level drops below the measuring range, the
conductivity cannot be determined.
Contact the Miele Customer Service Department.

The conductivity meter must be recalibrated.
Contact the Miele Customer Service Department.

The connection to the conductivity meter has been
interrupted.
Contact the Miele Customer Service Department.
