Miele PG 8582 CD Operating Instructions Manual page 134

Problem solving guide
Problem
Drying during programme de-
activated
Wrong code entered
Test programme: test object
can now be removed
Programme cancelled
Programme continued
Peak load cut-out
All settings reset
134
Cause and remedy
Drying cannot be selected at the start of a programme
because drying is not available for the selected
programme.
Start the programme without drying.

Or:
Have the drying parameters for this programme adjusted

by the Miele Customer Service Department.
The PIN code entered is not the same as the code saved.
Enter the PIN code again.

Report the loss of the PIN code to the Miele Customer

Service Department.
This is not a fault.
A test programme is running to check performance. At
certain points in the programme the sequence is
interrupted so that samples can be taken.
Take a sample.

or
Wait. The programme will continue automatically in

approx. 30 seconds.
or
Continue the programme without delay by pressing the

Start/Stop button.
This is not a fault.
A programme which was running was cancelled by the
user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.
This is not a fault.
The process of cancelling a programme was not
completed.
The programme which was running continued without
interruption.
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
This is not a fault.
A user has restored factory default settings.
Confirm the message with OK.
