Advertisement
2-2. Start-up screen
When the Test mode is started, start-up screen appears on the LCD which enables to check the Firmware version.
1)
Press the [ENTER] button, and then the test item is shown on the LCD.
2)
2-3. Selection/execution of Test items
Select a test item with the [INC/YES] (forward)
1)
buttons or [DEC/NO] (backward) button.
* The first item (No. 01) can be jumped to the last
item (No. 35) with the [DEC/NO] button. Also the
last item (No. 35) can be jumped to the first item (No.
01) with the [INC/YES] button.
Press the [ENTER] button to execute the test item.
2)
TEST
Firm
X.XX.X
Kernel
X.XX.XX-XXXXXX.XX.X
[ENTER] : Test Start
[STORE] : Factory Set
[EXIT] : Exit
[PLAY] : Start Sending USB Test Packet
Pressing the [ENTER] button, enter the test item selection mode.
Pressing the [STORE] button, skip to the "Factory Set" screen.
Pressing the [EXIT] button, skip to the "Exit" screen.
* Don't press the [PLAY] button because this mode is unnecessary in repairs.
TEST
01 : EBUS ID Check
[DEC/NO]
[EXIT]
MONTAGE Test
Program
MONTAGE Test
Program
Press [ENTER]
2-4. How to continue testing when the test
result shows "OK" or "NG"
When the judgment "OK" or "NG" is shown on the
LCD, testing is finished and the display returns to the
test item selection screen. It is possible to execute the
same test again or another test item.
If no automatic judgment is shown, press the [EXIT]
button, and the display returns to the test item selec-
tion screen.
[INC/YES]
[ENTER]
MONTAGE6/MONTAGE7
55
Advertisement
Chapters
