Start-Up; Password Setting In P0000; Oriented Start-Up - WEG CFW-11 RB User Manual

Powering up and Startup

5.2 START-UP

The start-up procedure is described in three simple steps by using the existing parameter groups, Oriented
Start-up routine and the Basic Application group.
Steps:
1. Set the password for parameter modification.
2. Execute the Oriented Start-up routine.
3. Set the parameters of the Basic Application group.

5.2.1 Password Setting in P0000

Step Action/Result
Monitoring Mode
„
Press "Menu" (right
„
1
soft key)
Group "00 ALL
„
PARAMETERS" is
2
already selected
Press "Select"
„
Parameter "Access to
„
Parameters P0000:
3
0" is already selected
Pressione "Select"
„
To set the password,
„
press the Up Arrow
4
until number
5 is displayed in the
5
keypad

5.2.2 Oriented Start-Up

There is a group of parameters named "Oriented Start-up" that makes the converter settings easier. Within this
group there is a parameter P0317, through which it is possible to enter the Oriented Start-Up routine.
The Oriented Start-Up routine presents the main parameters on the HMI in a logical sequence, so that their setting,
according to the operation conditions, prepares the converter for the operation with the used line and motor.
In order to enter into the Oriented Start-up routine, follow the steps presented in
modifying parameter P0317 to 1 and then, setting all remaining parameters as they are prompted in the display.
The use of the Oriented Start-up routine for setting the converter parameters may lead to the automatic modification
of other internal parameters and/or variables of the converter.
During the Oriented Start-up routine, the message "Config" will be displayed at the left top corner of the keypad.
5-2 | CFW-11 RB
Display Indication
Run RB + LOC 618 V
400 A
618 V
380 V
15:45 Menu
Run RB + LOC 618V
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Run RB + LOC 618V
Access to Parameters
P0000: 0
Line Voltage
P0002: 380 V
Return 15:45 Select
Run RB + LOC 618V
P0000
Access to Parameters
0
Return 15:45 Save
Figure 5.1: Steps for allowing parameters modification via P0000
Step Action/Result
When number 5
„
is displayed in the
5
keypad, press "Save"
If the setting has been
„
properly performed,
the keypad should
display "Access to
6
Parameters P0000: 5"
Press "Return" (left
„
soft key)
7 Press "Return"
„
The display returns to
„
8
the Monitoring Mode
Figure 5.2 on page
Display Indication
Run RB + LOC 618V
P0000
Access to Parameters
5
Return 15:45 Salvar
Run RB + LOC 618V
Access to Parameters
P0000: 5
Line Voltage
P0002: 380V
Return 15:45 Select
Run RB + LOC 618V
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Run RB + LOC 618V
400 A
618 V
380 V
15:45 Menu
5-3, first