WEG CFW-11 RB User Manual page 61

The HMI can be installed or removed from the converter with or without AC power applied to the converter.
„
The HMI supplied with the product can also be used for remote command of the converter. In this case, use
„
a cable with male and female D-Sub9 (DB-9) connectors wired pin to pin (mouse extension type) or a market
standard Null-Modem cable. Maximum cable length: 10 m (33 ft). It is recommended the use of the M3 x 5.8
standoffs supplied with the product. Recommended torque: 0.5 N.m (4.5 lbf.in).
When power is applied to the converter, the display automatically enters the monitoring mode.
4-3 (a) presents the monitoring screen displayed for the factory default settings. By properly setting specific
converter parameters, other variables can be displayed in the monitoring mode or the value of a parameter can
be displayed using bar graphs or with larger characters as presented in
Active power:
+ Motorizing
- Regenerating
RB Control
Status do conversor:
- Run
- Ready
- Config
- Última falha: FXXX
- Último alarme: AXXX
- etc
Left soft key feature
Run RB + LOC
A
V
V
Run RB + LOC
400
(c) Example of a monitoring screen displaying a parameter with a larger font size
Control mode indication:
LOC: local mode
REM: remote mode
Run RB + LOC 618V
400 A
618 V
380 V
12:35 Menu
Right soft key feature
Clock
Settings via:
P0197, P0198, and P0199
(a) Monitoring screen with factory default settings
Monitoring parameters:
- Input current
618 V
- DC link voltage
100%
- Line voltage (Volts) (P0002)
77%
100%
P0205, P0206 and P0207: selection of parameters
12:35 Menu
that will be displayed in the monitoring mode
(b) Example of a monitoring screen with bar ghaphs
618V
Value of one of the parameters defined in P0205,
P0206, or P0207 displayed with a larger font size.
Set parameters P0205, P0206 or P0207 to 0 if it is
A
not desirable to display them
12:35 Menu
Figure 4.3: (a) to (c) Monitoring modes
Figure 4.3 on page 4-3
DC link voltage (Volts)
Monitoring parameters:
- Input current (Amps)
- DC link voltage (Volts)
- Line voltage (Volts) (P0002)
P0205, P0206 and P0207: selection of parameters
that will be displayed in the monitoring mode
Keypad (HMI)
Figure 4.3 on page
(b) and (c).
4
CFW-11 RB | 4-3