11. Information about transmitter, probes and modules
"Information" menu allows to access to information such as serial numbers, firmware version, date of last adjust-
ment and calibration, date of next service,...
To access to this menu:
• Tap
on the measurement screen.
• Tap the security code.
Default security code is 0101. This code can be modified in "Security/Connectivity" menu. See chapter 9.2
on page 25.
• Tap "Information".
11.1 Instrument and probes/modules information
"Information" menu is displayed.
• Tap "Instruments and probes".
• Tap "Instruments" or "Probes/modules".
The screen displays the following information:
• Model
• S/N (Serial Number)
• Build
• Firmware version
In case of a trouble with your device and when contacting the after-sale service or the hotline, this informa-
tion will be useful.
11.2 Adjustment and calibration information
This menu displays information about adjustment and calibration for probes and modules connected to the trans-
mitter.
"Information" menu is displayed.
• Tap "Adjustment & Calibration".
• Tap the requested probe or module.
• Tap the requested parameter depending on the probe or module previously selected.
The screen displays the following information:
• Last adjustment date
• Last calibration date
• Date of next service
11.3 Probe update
This menu allows to check if a firmware update is available for probes.
"Information" menu is displayed.
• Tap "Probe Update".
The screen displays the current probe firmware version. If no update is available, the following
message is displayed: "Probes are already running the latest firmware."
The screen displays the current probe firmware version. If an update is available, the following
message is displayed: "A new probe firmware is available. Installing the new probe firmware will
restart the transmitter. Measurements will neither be collected nor available during this process".
• Tap "Install".
The transmitter displays the following message: Updating probe X to x.x.xx (firmware version).
Do not disconnect the probe from the transmitter during this step.
Once the installation of the new firmware is finalized, the transmitter restarts and measurements are displayed.
Information about transmitter, probes and modules
27