Magmaweld DFM 1000 User Manual page 6

6 Safety Precautions
Falling Parts
May Cause Injuries
EN
Overuse Can Cause
The Overheating
Of The Machine
Power Supply Failure
Protection
Energy Efficiency
USER MANUAL | KULLANIM KILAVUZU
• Wrong positioning of the smoke, dust, odor absorption and filtration systems and other
equipment may cause serious injuries for people or may damage the objects.
• Always use the handles when relocating the smoke, dust, odor absorption and filtration systems.
Never pull from the cables or the flex arms.
• Before carrying the smoke, dust, odor absorption and filtration systems, unscrew all the
interconnections, lift and carry the small ones from their handles and the larges ones from their
carriage rings or by using appropriate lifting equipment, such as forklifts.
• Install your machine on flat platforms having maximum 8-10° slope that it does not fall over
and overturn. Choose the areas where there will be no risk of tripping of the cables, flex arms and
hoses and preventing the exit of the air absorbed.. In order to restrict the movement of the mobile
systems, close the locks of the front wheels.
• Ensure that operators can easily access the settings and connections on the machine.
• Observe the warning lights on the control panel and follow the instruction manual.
• Allow the machine to cool according to the operating cycle rates.
• Observe the coarse filter and main filter operating hours and replace them in time.
• Do not block the outlet of filtered air of the machine.
• Do not place filters in the ventilation openings of the machine without the manufacturer's
approval.
• The energy supply or fluctuations in the power supply after any interruption or interruption in
the power supply to the machine can cause a hazardous situation.
• Machines should not start unexpectedly,
• The parameters of the machines should not be changed uncontrollably if such a change may lead
to a dangerous situation,
• Stop command of the machine should not be prevented,
• No moving parts of the machine or any parts held by the machine should fall or dislodge,
• Automatic or manual stopping of moving parts in any way is prevented.
• The protective devices must remain fully active or issue a stop command.
• Do not expose the machine to rain, avoid splashing water or pressurized steam. be.
• Do not absorb flammable, explosive, heavy oil vapor, petroleum products, liquids.
This may cause serious injury, death, fire, explosion, and major damage.
• Turn off the machine if it will wait a long time without working. This will also extend the life of
the filters.
DFM 1000 - 1250 - 1500
www.magmaweld.com